When troubleshooting traffic flows through the Palo Alto NGFW, it can be difficult to see what’s happening. Using the logs from the GUI can help.

An alternative is, to use the command line “show session all filter destination [IP]“. This shows you a filtered view of stateful sessions going through the firewall. It provides information like state, source/destination, translated IP/Port. An example is shown below. (Use the context sensitive help if you need more options)

admin@PA-FW> show session all filter destination

ID Application State Type Flag Src[Sport]/Zone/Proto (translated IP[Port])
Vsys Dst[Dport]/Zone (translated IP[Port])
37167 web-browsing ACTIVE FLOW *NS[55927]/trust/6 ([40416])
vsys1[443]/untrust ([443])

Once you have the session ID (in the case above the session ID is 37167), use the command “show session id 37167” to drill down further into the information within that session.

admin@PA-FW> show session id 37167
Session 37167

c2s flow:
 source: [trust]
 proto: 6
 sport: 55927 dport: 443
 state: ACTIVE type: FLOW
 src user: test\robert
 dst user: unknown
 qos node: ethernet1/1, qos member Qid 0
 match src interface: any
 match src address: ('any ',)

s2c flow:
 source: [untrust]
 proto: 6
 sport: 443 dport: 40416
 state: ACTIVE type: FLOW
 src user: unknown
 dst user: test\robert

start time : Fri Jan 26 10:03:53 2018
 timeout : 60 sec
 time to live : 48 sec
 total byte count(c2s) : 1924
 total byte count(s2c) : 5115
 layer7 packet count(c2s) : 14
 layer7 packet count(s2c) : 10
 vsys : vsys1
 application : web-browsing
 rule : Rule 2
 session to be logged at end : True
 session in session ager : True
 session synced from HA peer : False
 address/port translation : source + destination
 nat-rule : NAT-Outside(vsys1)
 layer7 processing : completed
 URL filtering enabled : True
 URL category : Rule 2
 session via syn-cookies : False
 session terminated on host : False
 session traverses tunnel : False
 captive portal session : False
 ingress interface : ethernet1/2
 egress interface : ethernet1/1
 session QoS rule : N/A (class 4)
 tracker stage l7proc : proxy timer expired

As you can see above, the amount of information can be very helpful for troubleshooting.┬áIf you suspect a particular session is causing a problem, you can clear with the command “clear session ID 37167